Filter
Top Products
2 PREFACE: General Conventions
M208 INTERNAL ARCHITECTURE on page 89
Explanation of the M208’s internal operating architecture and logic.
USING THE M208’S COMMAND SET on page 93
Full reference section based on the M208’s command set.
USING NPWIN on page 127
Explanation of using NPWin to configure and manage the M208.
USING THE M208’S ADDITIONAL OPTIONS on page 131
Introduction to some of the print enhancements provided by the M208.
TROUBLESHOOTING THE M208 on page 159
Helpful hints and steps to consider when you run into problems in any print setup.
GETTING HELP WITH THE M208 on page 171
Information on Microplex’s service and support procedures including Technical Sup-
port, upgrading, and warranty.
M208 SPECIFICATIONS on page 177
Full details about the M208’s hardware and software specifications.
GLOSSARY on page 195
Definitions of words, abbreviations, and acronyms used in this manual.
APPENDIX A on page 203
Useful information on setting up your printing environment.
APPENDIX B on page 207
Repeater specifications.
General Conventions
These are some of the conventions followed in this manual:
• At the bottom of each page is the name of the chapter, the section, and the page
number.
• The header contains an icon to represent which chapter you are currently reading.
• Names of other publications and references to other sections in this manual are in
italics.
?
B
A
C
unit
host