Filter
Top Products
USING THE M208’S COMMAND SET: npsh Command Set 123
store tcpip opts [-]ipforward
Enables the IP forwarding or routing functions of the M208. By default, the
gateway is disabled. This command must be used in conjuction with the
store tcpip proxy command below.
store tcpip proxy add [host|net]
targetipaddress
[
/tar-
getnetmask
]
Enables the M208 to respond to ARP requests for IP addresses that are differ-
ent than the interface configuration of the M208.
store tcpip proxy del
targetipaddress
Removes this entry from the proxy ARP table.
store tcpip route add|del default
routeripaddress ifnum
Add or delete a default router entry in the M208’s routing table for the NIT
module specified by ifnum.
store tcpip route add [host|net]
targetipaddress
[/
target-
netmask
]
routeripaddress ifnum|com1|com2
[
metric
]
Add a specific route to the M208’s routing table.
store tcpip route add 192.75.30.11 192.75.30.3 1
stores a host with IP address 192.75.30.11 into the unit’s routing table for the
first NIT module. The router’s IP address is 192.75.30.3.
store tcpip route add|del default
routeripaddress ifnum
Add or delete a default router entry in the M208’s routing table.
store tcpip route del [host|net]
targetipaddress ifnum
Delete a specific route from the routing table of the NIT module specified by
ifnum.
store tcpip tcp access [root] add|del
ipaddress
[/
net-
Examp
l
e