Filter
Top Products
CONFIGURING THE M208 FOR TCP/IP: M208 Configuration 41
8 Save these configurations to EEPROM. Enter:
save
9 Verify the IP address and netmask. Enter:
list stored tcpip
These are now stored in EEPROM.
10 After configuration, turn the M208 off, then on. This reboots the M208 and auto-
matically logs you out of the terminal session.
11 Test the equipment and configuration after installation is complete. Enter at the
shell prompt on your UNIX machine:
ping
ipname
Restoring to Factory Defaults
If at any time you’d like to restore the M208’s network settings to their original state,
you can do so with an npsh command or by utilizing jumpers within the M208 itself.
Please see Restoring To Factory Defaults on page 135 for more details on this pro-
cess.