Filter
Top Products
USING THE M208’S COMMAND SET: npsh Command Set 115
four digit hex value you’d like.
If you change the key value in npscramble.c, you must recompile the source
code and then use this key in the set sysinfo command.
set sysinfo dns
ipaddress
Set the DNS server’s IP address so the M208 can resolve names used with
ping and telnet. Please see ping on page 103 or telnet on page 124.
set sysinfo email
emailname@ipaddress
Set the user’s email address to receive printer logging information. email-
name is the IP name of the user to send mail to. ipaddress is the IP address
where the mail is stored. See also set logpath on page 108 to set printer log-
ging to email.
set sysinfo location [
locationstring
]
Set the physical location of the M208. If the locationstring is not included in
the syntax, the field is emptied.
set sysinfo loginfo [[-]sys] [[-]tcp] [[-]ipx] [[-]spx]
Select the M208 debugging information type. Usually this information
includes unexpected errors or exceptions from the unit and can be broken
down into:
sys General system messages.
tcp TCP stack messages.
ipx IPX stack messages.
spx SPX stack messages.
This debugging information is from the M208 only, not from the printer.
Please see set logpath on page 108 and Capturing Printer Feedback on page
134 for details on acquiring printer logging.
Note
Note