Filter
Top Products
82 CONFIGURING THE M208 FOR WINDOWS: TCP/IP Setup
then be created which will include FTP, Telnet, etc.
At this point, you will be prompted with a dialogue box asking for the TCP/IP net-
work settings (i.e. IP address and netmask) for this WfW station. Fill these in at this
time.
Windows 95 NetBIOS Network Software Installation
1 Make sure that File and Printer Sharing for Microsoft Networks is installed in
your Network setup. If not, you’ll need to perform the following steps.
2 Open Settings:Control Panel folder.
3 Double click on the Network icon.
4 Select Add.
5 Select Service.
6 Select File and Printer Sharing for Microsoft Networks from the list.
7 Click OK.
8 Click OK again since this service will now show in the list to the left.
Configuring TCP/IP On Your Windows Workstations
Since TCP/IP is used as the data transfer protocol, IP addresses and netmasks must be
assigned to your Windows workstation(s) if you haven’t already done so.
If you are not familiar with IP addresses and are sure that this network will not go
onto the Internet, the following are some sample settings to use:
IP Address Netmask
Host 1 192.1.1.1 255.255.255.0
M208 192.1.1.2 255.255.255.0
Host 2 192.1.1.3 255.255.255.0
and so on...
The following sections will detail how you configure TCP/IP settings on the different
Windows platforms.
Note