Filter
Top Products
104 USING THE M208’S COMMAND SET: npsh Command Set
M208 can resolve the IP name. Please see set sysinfo on page 114 for more
information.
reset
reset
Restore current settings to those stored in EEPROM. Performs a warm boot or
hardware reset, simulating a power-on reset. Use this after a power failure.
save
save
Save the current settings to EEPROM. These parameters include: system
information, destinations, models, logpaths, variables, I/O ports, and port-
maps. Resetting the unit is not required.
save default
Caution
This command overwrites everything and saves factory settings of all parame-
ters to EEPROM, except the factory-programmed Ethernet addresses. The
changes do not affect the current operating parameters until the M208 is reset.
See also: load on page 102, reset on page 104, and Set Commands on page
104.
Set Commands
Change the current parameters. The three command possibilities are:
set
choice parameters
Set some parameters.
set
choice
from default Set default parameters.
set
choice
from stored Set stored parameters from EEPROM.
choice and parameters can be any of the following options described next.
Once you have set any parameters, you need to issue a save command to store
these new values to EEPROM.
Note