Filter
Top Products
USING THE M208’S COMMAND SET: npsh Command Set 97
[-]li Enables or disables link integrity on a port. This command is
only applicable to port numbers one through eight (10Base-T
ports).
[-]revrxpol Enables or disables reverse receive polarity on a port. This
command is only applicable to port numbers one through
eight (10Base-T ports).
[-]sqe Enables of disabled the SQE test on port nine. This command
is only applicable to port nine, the AUI port.
See also: list hub on page 99 and Hub Configuration on page 21.
Debug Commands
The debug set of commands displays detailed debugging information about
memory, the network interface, and protocols.
debug
debug ip|lpq|mem|netbios|nif|novell|tcp
Display debugging information for a particular module.
disable
disable
ioportname
|
destname
Disable the specified I/O port so jobs are queued but not printed or disable the
specified destination so any new jobs are rejected. ioportname is one of the
three I/O ports on the unit and destname is the name of one of the unit’s desti-
nations.
See also: enable on page 97, list dest on page 99, list com1|com2 on page 98,
and list prn on page 100.
enable
enable
ioportname
|
destname
Enable the specified I/O port so jobs queued are printed or enable the speci-
fied destination so new jobs are processed. ioportname is one of the three I/O