Filter
Top Products
70 CONFIGURING THE M208 FOR NOVELL: Host Configuration
20 Press <Enter> to use the default.
Usually this is fine.
Returns you to the queue list.
21 Press <Escape> until you have exited
PCONSOLE.
You’re now at the command prompt.
22 Start PSERVER. Starts the PSERVER so the M208 can ser-
vice it as an RPRINTER.
23 In SYS VOLUME on the file server,
change to the \LOGIN directory.
You will be at this prompt.
24 Create a directory named after the
M208. By default, this will be
M_xxxxxx where xxxxxx is the last
six digits of the unit’s Ethernet
address. (e.g. M_000BF5)
This directory is created.
25 Within this directory, create a file
called CONFIG and open it for edit-
ing.
A blank file displays.
26 Enter the line:
set rprinter add
pservername printernumber
destname
where pservername
equals the existing PSERVER’s name,
printernumber equals the defined
number for this printer in that
PSERVER, and destname equals an
M208 destination (e.g. d1prn,
d3com2, etc.).
One entry is written in the file. One entry is
required for each RPRINTER serviced by
the M208.
27 Reboot the M208 to enable these
changes.
The M208 will boot up and read this entry
from the CONFIG file and set itself to act
as an RPRINTER.
Step Action Result of Action