Filter
Top Products
USING THE M208’S COMMAND SET: npsh Command Set 103
-V Show number of bytes printed.
-onlcr Insert a CR character before LF characters.
-ttabwidth Number of spaces for the tab in the range of 1 to 16.
-off Generate a FF character at the end of the job.
-oeof Generate an EOF character at the end of the job.
-uusername The name of the user that will be printed on the banner page.
-ffilename The name of the file that will be printed on the banner page.
lp can only be used with a remote command (i.e. rsh/rcmd/remsh).
rsh spike lp -d d1prn -off < test.txt
prints the file test.txt, followed by a formfeed to the M208 destination d1prn
on the Print Server named spike.
lpstat
lpstat
Display active and queued jobs on the Print Server and I/O port status.
See also: cancel on page 96.
ping
ping
ipname
Ping another TCP/IP host on the network indicated by ipname.
ping [-s]
ipname
[
packetsize
[
count
]]
Continually ping another TCP/IP host on the network specified by ipname.
This can be an IP address or an IP name. packetsize is the datagram packet
size which defaults to 64 bytes if no size is included in the syntax. count is the
number of requests to be sent.
To utilize the IP name, the DNS server’s IP address must be set first so the
Note
Examp
l
e
Note