Filter
Top Products
102 USING THE M208’S COMMAND SET: npsh Command Set
list user
list user [
userid
|all]
List current settings of a particular user indicated by userid, or all users. Cur-
rent settings include user ID and permissions.
See also: User Accounts and Permissions on page 94, list logins on page 100,
and set user on page 117.
list var
list var
List current settings of all variables.
See also: Variable Definitions on page 177, set var on page 117, and Vari-
ables on page 91.
load
load
Load the settings stored in EEPROM and use them as the current settings.
These settings include: destinations, models, logpaths, user, TCP, I/O ports,
variables, system information, and portmaps. This does not affect network
parameters. Use this after a power failure to restore settings saved in
EEPROM.
load default
Load the factory settings and use them as the current settings. Use this in
combination with store net from default when reinstalling the M208.
See also: save on page 104 and store tcpip on page 122.
lp
lp
options
-d
destname
Print to the M208 using standard TCP/IP rsh/rcmd/remsh. destname is the
name of the M208 destination. This command in default mode will show any
parallel port printer errors to the user. The options are:
-v Show incremental byte counts as the job is printing and show
the job’s position in the queue as it moves to the top.