Honeywell VM2 Laptop User Manual


 
5 - 26
Ignition Control/Ignition On
Select either the Ignition Control/Ignition On or the Ignition Control/Ignition Off power scheme/plan when ignition
control of the Thor VM2 power on process is desired.
The Thor VM2 aromatically switches between the Ignition Control/Ignition On or the Ignition Control/Ignition Off
power schemes/plans depending on the state of the vehicle ignition input.
The following default timeouts are used in the Ignition Control/Ignition On power scheme./plan
Note: By default Sleep is disabled and Hibernate is enabled. Because the Thor VM2 with Windows Embedded
Standard 7 or Windows 7 Professional cannot transition from Sleep to Hibernate due to a limitation of the
operating system, Sleep is disabled. Power savings are significantly greater using Hibernate.
The ignition input wire must be connected. If the user selects this power scheme/plan but the ignition is Off, the
Ignition Control/Ignition Off scheme/plan is used instead.
Windows Embedded Standard 2009
Setting
Plugged In
(AC or DC
Power)
Running on
Batteries
(UPS Power)
Turn off monitor 30 minutes 1 minute
Turn of hard disks 30 minutes 1 minute
System standby/sleep 5 hours 10 minutes
System hibernate Never 20 minutes
Windows Embedded Standard 7, Windows 7 Professional
Setting
Plugged In
(AC or DC Power)
On Battery
(UPS Power)
Dim the display Never Never
Turn of the display 30 minutes 1 minute
Put the computer to sleep Never (see note) Never (see note)
Hibernate after 300 minutes 20 minutes