Filter
Top Products
4 - 16
Connect Cables
There are many cables available for the Thor VM2 including power cables, and data/ communication cablesThor VM2.
Strain Relief Cable Clamps
Equipment Required: Phillips screwdriver (not supplied by Honeywell)
There are five strain relief cable clamps secured to the Thor VM2 Quick Mount Smart Dock.
Use the strain relief clamps to secure audio, power, and I/O cables attached to the Thor VM2 dock.
1. Determine the proper strain relief cable clamp. There are three sizes of cable clamps on the Thor VM2 which should
be matched to the cable to be secured. For example, the largest clamp (on the left when viewing the back of the Thor
VM2) is designed to secure the power cable.
2. Remove the strain relief clamp from the Thor VM2 by turning the screw counterclockwise. Put the screw aside in a
safe location.
3. Slide the strain relief clamp over the cable.
4. Using a Phillips screwdriver and the screw that was removed, refasten the clamp holding the cable to the Quick Mount.
Do not stretch the cable. Leave enough slack in the cable to allow it to be connected and disconnected easily when
needed.
5. Continue in this manner until all cables are secured to the Thor VM2 dock.