Filter
Top Products
334 DS6000 Series: Concepts and Architecture
Figure B-4 Specify ASPs to Add Units to
6. The Confirm Add Units panel will appear for review as shown in Figure B-5. If everything is
correct, press Enter
to continue.
Figure B-5 Confirm Add Units
7. Depending on the number of units you are adding, this step could take some time. When it
completes, display your disk configuration to verify the capacity and data protection.
Adding volumes to an Independent Auxiliary Storage Pool
Independent Auxiliary Storage Pools (IASPs) can be switchable or private. Disks are added
to an IASP using the iSeries navigator GUI. In this example, we are adding a logical volume
to a private (non-switchable) IASP.
1. Start iSeries Navigator. Figure B-6 on page 335 shows the initial panel.
Specify ASPs to Add Units to
Specify the ASP to add each unit to.
Specify Serial Resource
ASP Number Type Model Capacity Name
21-662C5 4326 050 35165 DD124
21-54782 4326 050 35165 DD136
1 75-1118707 1750 A85 35165 DD006
F3=Exit F5=Refresh F11=Display disk configuration capacity
F12=Cancel
Confirm Add Units
Add will take several minutes for each unit. The system will
have the displayed protection after the unit(s) are added.
Press Enter to confirm your choice for Add units.
Press F9=Capacity Information to display the resulting capacity.
Press F12=Cancel to return and change your choice.
Serial Resource
ASP Unit Number Type Model Name Protection
1 Unprotected
1 02-89058 6717 074 DD004 Device Parity
2 68-0CA4E32 6717 074 DD003 Device Parity
3 68-0C9F8CA 6717 074 DD002 Device Parity
4 68-0CA5D96 6717 074 DD001 Device Parity
5 75-1118707 1750 A85 DD006 Unprotected
F9=Resulting Capacity F12=Cancel