Filter
Top Products
Electrical Specifications
DC Electrical Specifications
Copyright © 2008 Marvell Doc. No. MV-S104859-U0 Rev. E
December 2, 2008, Preliminary Document Classification: Proprietary Information Page 81
8.5 DC Electrical Specifications
8.5.1 General 3.3V (CMOS) DC Electrical Specifications
The DC electrical specifications in Table 39 are applicable for the following interfaces and signals:
JTAG
RGMII (10/100 Mbps)/GMII/MII/MMII
Secure Digital Input/Output (SDIO)
S/PDIF / I
2
S (Audio)
Transport Stream (TS)
NAND flash
UART
MPP
PTP
SYSRSTn
In the following table, for the JTAG, SDIO, S/PDIF / I
2
S, TS, NAND flash, UART, PTP, and MPP
interfaces, VDDIO means the VDDO power rail. For the RGMII/GMII/MII/MMII interface, VDDIO
means the VDD_GE_A and VDD_GE_B power rails.
Table 39: General 3.3V Interface (CMOS) DC Electrical Specifications
Note
See Section 1.3, Internal Pull-up and Pull-down Pins, on page 48 for internal
pullup/pulldown information.
Parameter Symbol Test Condition Min Typ Max Units Notes
Input low level VIL -0.3 0.8 V -
Input high level VIH 2.0 VDDIO+0.3 V -
Output low level VOL IOL = 2 mA - 0.4 V -
Output high level VOH IOH = -2 mA 2.4 - V -
Input leakage current IIL 0 < VIN < VDDIO -10 10 uA 1, 2
Pin capacitance Cpin 5 pF -
Notes:
General comment: See the Pin Description section for internal pullup/pulldown.
1. While I/O is in High-Z.
2. This current does not include the current flowing through the pullup/pulldown resistor.