Chapter 1 Introduction
National Instruments Corporation 1-5 PC-LPM-16/PnP User Manual
Optional Equipment
National Instruments offers a variety of products to use with your
PC-LPM-16/PnP board, including cables, connector blocks, and other
accessories, as follows:
• Cables and cable assemblies, shielded and ribbon
• Connector blocks, shielded and unshielded with 50-pin screw
terminals
• SCXI modules and accessories for isolating, amplifying, exciting,
and multiplexing signals for relays and analog output. With SCXI
you can condition and acquire up to 3,072 channels.
• Low channel-count signal conditioning modules, boards, and
accessories, including conditioning for strain gauges and RTDs,
simultaneous sample-and-hold circuitry, and relays
For more specific information about these products, refer to your
National Instruments catalogue or call the office nearest you.
Custom Cables
National Instruments currently offers a cable termination accessory, the
CB-50, for use with the PC-LPM-16/PnP. This kit includes a
terminated, 50-conductor, flat ribbon cable and a connector block.
Signal input and output wires can be attached to screw terminals on the
connector block and connected to the PC-LPM-16/PnP I/O connector.
The CB-50 is useful for the initial prototyping of an application or in
situations where PC-LPM-16/PnP interconnections are frequently
changed. Once you develop a final field wiring scheme, however, you
may want to develop your own cable. This section contains information
and guidelines for the design of custom cables.
The PC-LPM-16/PnP I/O connector is a 50-pin, male, ribbon cable
header connector. The following list gives recommended part numbers
for use with your PC-LPM-16/PnP board:
• Electronic Products Division/3M (part number 3596-5002)
• T&B/Ansley Corporation (part number 609-5007)
a.Book : e.chapter 1 Page 5 Wednesday, November 20, 1996 6:36 PM