Filter
Top Products
ND-71548 (E) CHAPTER 3
Page 195
Issue 2
INSTALLATION PROCEDURE
5. TERMINATION OF THE CABLES BETWEEN THE PBX AND THE MDF OR ATTCON ONTO THE CABLE
SUPPORT ASSEMBLY
NAP-200-013
Sheet 9/13
Cable Running from the PBX to MDF,
ATTCON, MAT, and SMDR
START
Removing the Cable Support Assembly. Remove the Cable Support Assembly from the
BASEU. (See Figure 013-4.)
Peeling the cable cover Referring to Table 013-1, confirm the cable
terminating locations on the Cable Support
Assembly.
At the cable terminating locations, peel off the
cable cover as shown on Figure 013-5.
Terminating the cable Referring to Figure 013-5, wind the clamp (M-
398902/E0809A) onto the cable portion from
which the cover has been peeled off.
Referring to Figure 013-6, terminate the cable
onto the Cable Support Assembly.
When all the cables have been terminated to the Cable Support Assembly A, likewise terminate the
cables onto the Cable Support Assembly B, C, D, E in order.
END