Filter
Top Products
ND-71548 (E) CHAPTER 3
Page 273
Issue 2
INSTALLATION PROCEDURE
21. HOLD/START/RELEASE/SWAP
This item specifies the locations of HOLD, START and RELEASE key.
(a) Press the desired number. An asterisk (*) shows the selected number.
1. Original setting
2. Swapped setting
Note: The locations of each key changes as shown below.
SRC: Return to Configuration Menu
Note: Default setting is “1: ORIGINAL”.
(b) Press the SRC key. The display returns to Configuration Menu.
(c) When configuration data assignment is completed, proceed to UPDATING CONFIGURATION DA-
TA. When the other item is also specified, return to SELECTION OF CONFIGURATION ITEM.
NAP-200-016
Sheet 41/44
Installation of the DESK CONSOLE and
Cable Connection
[HOLD/START/RELEASE/SWAP] SRC: menu
*1: ORIGINAL
2: SWAPPED
ORIGINAL SETTING SWAPPED SETTING
RELEASE START
HOLD RELEASE
START HOLD
[CONFIG MENU P3] VER x DEST: next page
1: REC VOLUME Release: exit
2: BLF Answer: update
3: HOLD/START/RELEASE/SWAP