Filter
Top Products
ND-71548 (E) CHAPTER 3
Page 269
Issue 2
INSTALLATION PROCEDURE
17. REC CONTROL
This item specifies the operation mode of a recording device. The following two types of modes are available:
Manual mode
Manual mode is available when the REC circuit card is mounted in the system. When the REC key is
pressed, the system starts recording and the REC lamp lights. When the REC key is pressed again, the re-
cording stops and the REC lamp goes off.
Automatic mode
In Automatic mode, a dedicated recording device is directly connected to the REC connector. When a call
is connected/disconnected, the system starts/ends recording automatically. Note that the REC key is not ef-
fective in Automatic mode.
(a) Press the desired number. An asterisk (*) shows the selected number.
1. Manual mode
2. Automatic mode
SRC: Return to Configuration Menu
Note: Default setting is “1: MANUAL”.
(b) Press the SRC key. The display returns to Configuration Menu.
Note: Do not change this data.
(c) When configuration data assignment is completed, proceed to UPDATING CONFIGURATION DA-
TA. When the other item is also specified, return to SELECTION OF CONFIGURATION ITEM.
NAP-200-016
Sheet 37/44
Installation of the DESK CONSOLE and
Cable Connection
[REC CONTROL] SRC: menu
*1: MANUAL
2 : AUTO
[CONFIG MENU P2] VER x DEST: next page
1: REC CONTROL Release: exit
2: PAGE CONTROL Note Answer: update
3: SUP CONNECTION