Filter
Top Products
CHAPTER 5 ND-71548 (E)
Page 364
Issue 2
INSTALLATION TEST PROCEDURE
NAP-200-050
Sheet 2/3
IP PAD Connection Test
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
The following explains how to solve the problems. When the problem can not be solved by the step, go to
the next step.
1) Remove and insert the circuit card.
2) Make sure office data and mount location data by using AFPC, ACTK, and ALIDL.
3) Initialize the circuit card.
4) Re-download the firmware into the circuit card by using CD.
5) Replace the circuit card.
START
[1] Confirm that OPE lamp (*A) on IP PAD is lighting. (*A)
The following explains how to solve the problems. When the problem can not be solved by the step, go to
the next step.
1) Remove and insert the circuit card.
2) Initialize the circuit card.
3) Re-download the firmware into the circuit card by using CD.
4) Replace the circuit card.
[2] Confirm that VC0-3 lamps (*B) on IP PAD are lighting when using voice compression sub card. (*B)
The lamps on the circuit card turn on in the following condition:
-When a sub card (Sub PKG0) is installed : VC0 and VC1 turn on.
-When two sub cards (Sub PKG0/1) are installed : VC0, VC1, VC2 and VC3 turn on.
Make sure LAN cables (straight) are connected correctly.
Check LAN cable by a tester or other equipment.
Check the normality of network equipment (SW HUB, Router, etc.).
[3] Confirm that LINK lamp (*C) on IP PAD is lighting, which indicates that the circuit card is connected to
the network physically.
YES
NO
YES
NO
YES
NO
A