Filter
Top Products
Chapter 19. Switch Stacks | 355
ProSafe M4100 and M7100 Managed Switches
4. Continue with the boot of operational code.
5. Once the stack is up, download the saved configuration back to the master
. This
configuration should then be automatically propagated to all members of the stack.
Copy Master Firmware to a Stack Member (Web Interface)
1. Select System > Management > Basic > Stack Configuration.
A screen similar to the following displays.
2. In the Copy Master Firmware to Unit list, select 2.
3. Click Apply.
Configure a Stacking Port as an Ethernet Port
AX742
2/0/28
AX742
1/0/28
Figure 38. Configuring a stacking port as an Ethernet port
Follow these steps to set up the topology:
1. Insert the
AX742 into the I/O module on the switch.
2. Configure the switch
A and B as described in the following instructions.
3. Connect the
AX 742 with stack cable.
4. Reboot Switch
A and Switch B.