Filter
Top Products
Chapter 29. DHCP L2 Relay and L3 Relay | 499
ProSafe M4100 and M7100 Managed Switches
A screen similar to the following displays.
b. Under DHCP Pool Configuration, enter the following information:
• In the Pool Name list, select Create.
• In the Pool Name field, enter dhcp_server_second.
• In the
Type of Binding list, select Dynamic.
• In the Network Number field, enter 10.200.2.0.
• In the Network Mask field, enter 255.255.255.0.
As an alternate, you can enter 24
in the Network Prefix Length field.
c. Click Add.
The dhcp_server_second name is now added to the Pool Name
drop-down list.
Configure a DHCP L3 Switch
CLI: Configure a DHCP L3 Relay
1. Enable routing on the switch.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#
2. Create a routing interface and enable RIP on it.
(Netgear Switch) (Config)#
(Netgear Switch) (Config)#interface 1/0/4
(Netgear Switch) (Interface 1/0/4)#routing
(Netgear Switch) (Interface 1/0/4)#ip address 10.100.1.2 255.255.255.0
(Netgear Switch) (Interface 1/0/4)#ip rip
(Netgear Switch) (Interface 1/0/4)#exit