Filter
Top Products
Chapter 32. Captive Portal | 549
ProSafe M4100 and M7100 Managed Switches
are used to configure captive portal. VSAs are denoted in the ID column and are comma
delimited (vendor ID, attribute ID).
Table 3. RADIUS Attributes for Configuring Captive Portal Users
RADIUS Attribute No. Description Range Usage Default
User-Name 1 User name to be authorized. 1–32 characters Required None
User-Password 2 User password. 8–64 characters Required None
Session-Timeout 27 Logout once session timeout is
reached (seconds). If the attribute is
0 or not present then use the value
configured for the captive portal.
Integer
(seconds)
Optional 0
Idle-Timeout 28 Log out once idle timeout is reached
(seconds). If the attribute is 0 or not
present, then use the value
configured for the captive portal.
Integer
(seconds)
Optional 0
WISPr-Max-Band
width-Up
14122, 7 Maximum client transmit rate (b/s).
Limits the bandwidth at which the
client can send data into the network.
If the attribute is 0 or not present,
then use the value configured for the
captive portal.
Integer Optional 0
WISPr-Max-Band
width-Down
14122, 8 Maximum client receive rate (b/s).
Limits the bandwidth at which the
client can receive data from the
network. If the attribute is 0 or not
present, then use the value
configured for the captive portal.
Integer Optional 0
CLI: Configure RADIUS as the Verification Mode
(Netgear Switch) (Config-CP 1)#radius-auth-server Default-RADIUS-Server
(Netgear Switch) (Config-CP 1)#verification radius
Web Interface: Configure RADIUS as the Verification Mode
1. Select Security > Control > Captive Portal > CP Configuration.