Filter
Top Products
Installing the BayStack 350 Switch
309979-A Rev 00
2-17
Initial Setup
In most cases the BayStack 350 switch can be installed and made operational
using the system default settings (see Appendix F, “Default Settings” for a list of
default settings for the BayStack 350 switch). The BayStack 350 switch is
designed for plug-and-play operation; however, certain parameters must be
configured for the switch management function to become fully operational. A
minimal configuration is required when you plan on remote management or TFTP
operations. In that case, you need to enter the IP address of the switch, the subnet
mask, and the gateway address (see Chapter 3, “Using the Console Interface” for
more information about configuring your BayStack 350 switch).
To set the IP address, subnet mask, and gateway address for the switch, follow
these steps:
1.
Apply power to the switch.
2.
After the Nortel Networks logo screen appears, press [Ctrl]-Y.
The Main Menu is displayed (Figure 2-13
). The Main Menu hierarchy is
described in Chapter 3, “Using the Console Interface.”
Figure 2-13. Main Menu
BayStack 350-24T Main Menu
IP Configuration/Setup...
SNMP Configuration...
System Characteristics...
Switch Configuration...
Console/Comm Port Configuration...
Display Hardware Units...
Spanning Tree Configuration...
TELNET Configuration...
Software Download...
Configuration File...
Display Event Log
Reset
Reset to Default Settings
Logout
Use arrow keys to highlight option, press <Return> or <Enter> to select option.