Filter
Top Products
Using the BayStack 350 10/100/1000 Series Switch
1-52
309979-A Rev 00
Trunk Configuration Screen for Switch S2
As shown in Figure 1-35
on page 1-48, switch S2 is set up with two trunk
configurations (T2 and T3). Both trunks connect directly to switch S1.
As in the previous screen examples, to set up a trunk configuration choose
MultiLink Trunk Configuration from the MultiLink Trunk Configuration Menu
screen.
Figure 1-38
shows the MultiLink Trunk Configuration screen for switch S2.
Figure 1-38. MultiLink Trunk Configuration Screen for Switch S2
Switch S2 is configured as follows:
• Trunk (read only) indicates the trunks (1 to 6) that corresponds to the switch
ports specified in the Trunk Members fields.
MultiLink Trunk Configuration
Trunk Trunk Members STP Learning Trunk Mode Trunk Status
----- ---------------------------- ------------ --------------- ------------
1 [ 25 ][ 26 ][ ][ ] [ Normal ] Basic [ Enabled ]
2 [ 1 ][ 3 ][ ][ ] [ Normal ] Basic [ Enabled ]
3 [ ][ ][ ][ ] [ Normal ] Basic [ Disabled ]
4 [ ][ ][ ][ ] [ Normal ] Basic [ Disabled ]
5 [ ][ ][ ][ ] [ Normal ] Basic [ Disabled ]
6 [ ][ ][ ][ ] [ Normal ] Basic [ Disabled ]
Trunk Trunk Name
----- ------------------
1 [ S2:T2 to S1 ]
2 [ S2:T3 to S1 ]
3 [ Trunk #3 ]
4 [ Trunk #4 ]
5 [ Trunk #5 ]
6 [ Trunk #6 ]
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.