Filter
Top Products
Using the BayStack 350 10/100/1000 Series Switch
2-8
309979-A Rev 00
Connecting the 10BASE-T/100BASE-TX Ports
Connect devices to the 10BASE-T/100BASE-TX ports as shown in Figure 2-5
.
The BayStack 350 switch 10BASE-T/100BASE-TX ports are configured with
RJ-45 connectors that are wired as MDI-X ports. As in conventional Ethernet
repeater hubs, the BayStack 350 switch ports connect via straight-through cables
to the network interface card (NIC) in a node or server. When connecting to an
Ethernet hub or to another switch, you must use a crossover cable. See
Appendix E, “Connectors and Pin Assignments,” for more information.
By default, all BayStack 350 switch 10BASE-T/100BASE-TX switch ports are set
with autonegotiation enabled. This feature allows any port to match the best
service provided by the connected station, up to 100 Mb/s in full-duplex mode.
To connect the RJ-45 port cables, insert the cable plug into the appropriate port
connector until the release tab snaps into the locked position (Figure 2-5
).
Figure 2-5. 10/100 Mb/s Port Connections
Note:
The 10BASE-T/100BASE-TX ports must use Category 5 UTP cable to
accommodate the 100BASE-TX functionality.
BS35073A
Uplink/Expansion Module
2826 2725
Comm Port
17 1913 15 21
18 2014 16 22 24
23
Status
Pwr
Activity
Activity
10/100
10/100
5713 9
682 4 10 12
11
3
Comm Port
Activity
100
10
F Dx
400-4TX MDA
400-4TX MDA
RJ-45 connector
BayStack 350-24T