Filter
Top Products
Using the BayStack 350 10/100/1000 Series Switch
3-34
309979-A Rev 00
Port Configuration
The Port Configuration screen (Figures 3-13 and 3-14) allows you to configure a
specific switch port or all switch ports. You can set the switch ports to
autonegotiate for the highest available speed of the connected station, or you can
set the speed for selected switch ports.
You can disable switch ports that are trunk members, however, the screen prompts
for verification of the request before completing the action. Choosing [Yes]
disables the port and removes it from the trunk.
Choose Port Configuration (or press p) from the Switch Configuration Menu
screen to open the Port Configuration screen.
Figure 3-13. Port Configuration Screen (1 of 2)
Note:
The Autonegotiation fields, the Speed fields, and the Duplex fields are
independent of MultiLink trunking, rate limiting, VLANs, IGMP Snooping,
and the STP.
Port Configuration
Port Trunk Status Link LnkTrap Autonegotiation Speed Duplex
---- ----- ------------ ----- ------- --------------- -----------------
1 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Half ]
2 [ Enabled ] Up [ On ] [ Enabled ] [ 10Mbs / Full ]
3 [ Enabled ] Up [ Off ] [ Disabled ] [ 10Mbs / Full ]
4 [ Enabled ] Up [ Off ] [ Disabled ] [ 100Mbs / Half ]
5 [ Enabled ] Down [ On ] [ Disabled ] [ 100Mbs / Half ]
6 1 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Full ]
7 1 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Full ]
8 [ Enabled ] Down [ Off ] [ Disabled ] [ 100Mbs / Half ]
9 1 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Full ]
10 [ Enabled ] Down [ On ] [ Disabled ] [ 100Mbs / Half ]
11 [ Enabled ] Up [ Off ] [ Disabled ] [ 10Mbs / Half ]
12 [ Enabled ] Up [ Off ] [ Disabled ] [ 10Mbs / Half ]
13 2 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Full ]
14 2 [ Enabled ] Up [ On ] [ Enabled ] [ 100Mbs / Full ]
More...
Press Ctrl-N to display choices for additional ports..
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.