Filter
Top Products
Using the Console Interface
309979-A Rev 00
3-89
The write threshold is reset when either of the following occurs:
• The BayStack 350 switch is reset.
• The firmware determines that compression is required for maintenance of the
event log’s flash memory.
Flash Update
Figure 3-39 shows an example of the event log entry for this type of event.
Figure 3-39. Sample Event Log Entry Showing Flash Update Status
Reset
The Reset option (accessed from the main menu) allows you to reset the BayStack
350 switch without erasing any configured switch parameters.
Resetting the switch takes approximately 5 seconds to complete. During this time,
the switch initiates a self-test that comprises various diagnostic routines and
subtests. The LEDs display various patterns to indicate that the subtests are in
progress.
The results of the self-test are displayed briefly (5 or 10 seconds) in the Self-Test
screen (Figure 3-40
), which is followed by the Nortel Networks logo screen
(Figure 3-41
).
Note:
The Self-Test screen remains displayed only if the self-test detects a
fatal error.
Entry Number: 13 sysUpTime: 12:20:38 Reset Count: 2
Flash configuration update operation (write or erase) failed.
Configuration information may be lost.