Using the BayStack 350 10/100/1000 Series Switch
3-72
304376-B Rev 00
Table 3-27 describes the Software Download screen fields.
LED Indications During the Download Process
The software download process is automated so that it runs to completion without
user intervention. The download process erases the contents of flash memory and
replaces it with a new software image; therefore, it is important that the download
process not be interrupted once initiated. When the download process is complete,
the switch is reset automatically and the new software image initiates a self-test.
The self-test results are displayed briefly in the BayStack 350 switch Self-Test
screen, which is followed by the console interface screens.
During the download process, the BayStack 350 switch is not operational. You can
monitor the progress of the download process by observing the LED indications.
Table 3-27. Software Download Screen Fields
Field Description
Image Filename
The software image load file name.
Default Value: Zero-length string
Range: An ASCII string of up to 30 printable characters
TFTP Server IP
Address
The IP address of your TFTP load host.
Default Value: 0.0.0.0 (no IP address assigned)
Range: Four-octet dotted-decimal notation, where each octet is represented
as a decimal value, separated by a decimal point
Start TFTP Load
of New Image
Specifies whether to start the download of the switch software image (default is No).
Use the spacebar to toggle the selection to Yes.
Press Enter to initiate the software download process.
Note:
The software download process can take up to 60 seconds to complete (or more
if the load host path is congested or there is a high volume of network traffic).
To ensure that the download process is not interrupted, do not power down the switch for
approximately 10 minutes.
Default Value: No
Range: Yes, No
kombk.book Page 72 Thursday, February 18, 1999 10:59 AM
