Filter
Top Products
309979-A Rev 00
F-1
Appendix F
Default Settings
Table F-1 lists the factory default settings for the BayStack 350 switch.
Table F-1. Factory Default Settings for the BayStack 350 Switch
Appears in this CI screen: Field: Default setting:
IP Configuration/Setup (page 3-7) BootP Request Mode BootP Disabled
In-Band Stack IP Address 0.0.0.0
(Not Used)
In-Band Switch IP Address 0.0.0.0
(no IP address assigned)
In-Band Subnet Mask 0.0.0.0
(no subnet mask assigned)
Default Gateway 0.0.0.0
(no IP address assigned)
SNMP Configuration (page 3-12) Read-Only Community String public
Read-Write Community String private
Trap IP Address 0.0.0.0
(no IP address assigned)
Community String Zero-length string
Authentication Trap Enabled
Link Up/Down Trap Enabled
System Characteristics (page 3-14) Reset Count 1
Last Reset Type Power Cycle
Power Status Primary Power
sysContact Zero-length string
(continued)