Filter
Top Products
109
Refer to the system controller’s operating instructions
before you login the system. After the log-in procedure, the
following operations are available to control the system.
The operation begins with selecting a monitor, then the
selected camera appears the active monitor.
■ Monitor Selection
Unit addresses are given to each monitor.
Rotary SW Mon 1 Mon 2 Mon 3 Mon 4
11234
The following is how to select a monitor.
1. Press the numeric button(s) to select the desired moni-
tor's unit address.
2. Press the UNIT button.
The selected monitor will be activated.
■ Priority Lock
You can apply or release priority lock by entering the func-
tion code. Monitor display is the same as those of terminal
mode. (Refer to p. xx for the illustrations.)
1. Select the desired monitor. (Refer to Monitor Selection).
2. Press the SHIFT button, and enter 101 by pressing the
numeric buttons.
3. Press the FUNCTION button. The function will be exe-
cuted.
If the priority lock mode is selected, the monitor number
will inversely appear on the active monitor.
4. To release the priority lock, do steps 2 and 3 again.
Note: This function will prevent operators in the terminal
mode from gaining control of a monitor. However, oper-
ators via the PS·Data protocol can still gain control.
MONITOR CONTROL