Filter
Top Products
123
TIME-LAPSE VCR CONTROL [NON-PANASONIC MODELS] (TERMINAL MODE)
A time-lapse VCR is operable with the system controller,
while connecting to the matrix switcher.
Notes:
• Before the use, it is necessary to install the
Multiplexer board in the matrix switcher, connect
the matrix switcher to the digital disk recorder, and
configure the system through WJ-SX150
Administrator Console, OSD SETUP MENU, and
time-lapse VCR's SETUP MENU. [Refer to p. 34
Installing the Multiplexer Board, p. 46 Connection
with the Time-lapse VCR (Non-Panasonic Models),
p. 52 WJ-SX150 SETUP MENU (OSD), and p. 64
WJ-SX150 ADMINISTRATOR CONSOLE.]
• You cannot display the setup menu of a time-lapse
VCR.
• You cannot control non-Panasonic time-lapse VCRs
from PS·Data system controllers.
The following is the procedure of a non-Panasonic model
time-lapse VCR.
■ Controlling the Time-lapse VCR
● To Operate the Multiscreen Display
The operations are the same as WJ-HD500 Series.
Refer to p. 117 Multiscreen Segment Switching.
● Manual Recording
Refer to the time-lapse VCR’s operating instructions for how
to operate.
● Normal Playback
1. Enter the recorder mode. (Refer to p. 116 Recorder
Mode.)
2. Do the playback procedure using the buttons on the
front panel. (Refer to the time-lapse VCR’s operating
instructions for how to operate.)
3. Press the PLAY button. The playback image will appear
on the monitor.
4. To display the spot picture, press the numeric buttons
corresponding to the desired camera number, then
press the CAM [SET] button. Then, the active monitor
number with “-H**” (** is the camera number)” will
appear on the LED display. (Refer to p. 117 Normal
Playback for the illustration.)
● Fast-forward
Refer to the time-lapse VCR’s operating instructions for how
to operate.
● Rewind
1. During the stop, press the REW button to rewind the
tape.
2. Press the STOP button to stop rewinding.
Note: Pressing the PLAY button during rewind will start
playback.