100
MODE: Lists the display mode on the moni-
tors.
SPOT: Spot mode
Tnn: Tour Sequence mode (nn is the tour
sequence number.)
SET: WJ-SX150 Setup mode
ALARM: Alarm Active mode
ACK: Alarm ACK mode
VLD H: VLD History Table
ALM H: Alarm History Table
SYS S: System Status Table
KB: Lists the system controller number or
PC.
OPE: Lists the operator number
PRI: Lists the priority number
3. To exit from the mode, press the CLEAR button.
● Moving the Event Display
Move the joystick while holding down the OSD, SHIFT and
3 buttons. (3) will move to the desired direction.
● Moving the Monitor Status*
Move the joystick while holding down the OSD, SHIFT and
4 buttons. (4) will move to the desired direction.
* Monitor number, controller number and monitor mode
● Moving All the Items
Move the joystick while holding down the OSD, SHIFT and
5 buttons. (1), (2), (3), and (4) will move to the desired
direction.
■ System Status Table
The table shows the current system status.
1. Select the desired monitor. (Refer to p. 90 Monitor
Selection.)
2. Press the button 9 while holding down the OSD button.
"OSD" will appear on the LED display, and the SYSTEM
STATUS table will appear on the active monitor as
shown in the figure.
The columns in the table indicate the states as shown in the
figure.
MON: Monitor number
CAM: Camera number
No number indicates no camera is
selected.
