Filter
Top Products
2Modem/DSU Commands
2-896800-A2-GB31-20 January 1997
Configuration Change Notification (ccn)
Use the ccn command to display the configuration events that have occurred on a COMSPHERE
device. You can also use this command to clear the memory area in the device where the
configuration events are stored.
For most commands, NMS enables you to specify the destination for the command’s results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level: Help Desk, Data Technician, Manager, System Administrator
Abbreviation: ccn
Restrictions: None
Routine: Yes
Schedule: Yes
Related Commands: Configuration Change Notification Enable/Disable (ccned)
Configuration Change Notification Input Form
The Configuration Change Notification input form contains the following fields:
Device(s) (Required field)
Enter the device(s) whose configuration changes will be displayed. One or more devices
may be specified. Standard addressing format applies to the input. For information on
device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network
Management System User’s/System Administrator’s Guide.
Test state (Required field)
Enter display to display configuration events for the device(s) specified.
Enter clear to display the configuration events for the specified device(s), and then clear
memory.
A pop-up menu is available listing valid selections.