Filter
Top Products
COMSPHERE 6800 Series Network Management System
2-150 January 1997 6800-A2-GB31-20
EIA Status (eias)
Use the eias command to display the status of EIA interface leads on a COMSPHERE
3400/4400 Series modem or a COMSPHERE 3600 Series DSU, a COMSPHERE 3800 Series
modem, or a DATAPHONE II APL modem, DDD modem, or 2700 Series DSU.
The eias command will also report the V.35 status of a 3600 Series DSU or a 3800 Series modem.
The DSU can be optioned for either a V.35 or an EIA-RS232 or RS366 interface. The V.35
interface supports speeds of up to 64 kbps and is typically used to connect the DSU to a front-end
processor. Regardless of the interface type, the leads that are supported are identical. For most
commands, NMS enables you to specify the destination for the command’s results and schedule its
execution. If the last page of the input form cannot accommodate the Destination for results and
Schedule execution fields, an additional page is provided. For a complete description of these
fields, refer to Chapter 1, Introduction.
Access Level: Help Desk, Data Technician, Manager, System Administrator
Abbreviation: eias
Alternate: eia
Restrictions: None
Routine: Yes
Schedule: Yes
Related Commands: None
EIA Status Input Form
This input form contains the following field:
Device(s) (Required field)
Enter the device(s) whose EIA interface leads states will be displayed. One or more
devices may be specified. Standard addressing format applies to the input. For
information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series
Network Management System User’s/System Administrator’s Guide.
EIA Status Results Form
A separate results form is displayed for each device specified. Each results form lists device
information for the specified device, the applicable set of leads, and the status of each lead.
Figure 2-46 and Figure 2-47 are Page 1 and Page 2 of a sample EIA Status results form for a
COMSPHERE 3800 Series modem.