Filter
Top Products
2Modem/DSU Commands
2-36800-A2-GB31-20 January 1997
Abort (abort)
(Disruptive)
Use the abort command to stop all tests currently running on a specified device(s). When sent to a
control device, the abort command can stop all tests in progress on the control device and/or all
tests in progress on its downstream devices. This command stops only tests that are currently in
progress. If a test is scheduled, the abort command will not stop the test unless the test is actually
running.
This command can be used for all COMSPHERE and DATAPHONE II devices.
For most commands, NMS enables you to specify the destination for the command’s results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level: Data Technician, Manager, System Administrator
Abbreviation: abort
Alternate: abt
Restrictions: An abort sent to any DATAPHONE II device, or any COMSPHERE device
set in DATAPHONE II diagnostic mode is interpreted as a subnetwork
abort, regardless of the abort option (subnetwork or selective) entered in
the input form.
Routine: Yes
Schedule: Yes
Related Commands: None
Abort Input Form
The Abort command input form contains the following fields:
Device(s) (Required field)
Enter the device(s) to which the abort command will be sent. One or more devices may be
specified. Standard addressing format applies to the input. For information on device
addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management
System User’s/System Administrator’s Guide.