Filter
Top Products
2Modem/DSU Commands
2-2056800-A2-GB31-20 January 1997
Training Time (tt)
Use the tt command to obtain training time information for a COMSPHERE 3400/4400 Series
control modem. The control modem determines its required training time and actual training time,
and updates these values at 1-minute intervals. The training times shown represent the longest
value over the 1-minute interval.
For most commands, NMS enables you to specify the destination for the command’s results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level: Help Desk, Data Technician, Manager, System Administrator
Abbreviation: Abbreviation: tt
Restrictions: None
Routine: Yes
Schedule: Yes
Related Commands: None
Training Time Input Form
This input form contains the following field:
Device(s) (Required field)
Enter the device(s) for which the training time information will be obtained. One or more
devices may be specified. Standard addressing format applies to the input. For
information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series
Network Management System User’s/System Administrator’s Guide.