Filter
Top Products
2Modem/DSU Commands
2-1876800-A2-GB31-20 January 1997
Receive Signal Level (rsl)
Use the rsl command to estimate the received signal level at DATAPHONE II Analog Private Line
(APL) modems or Direct Distance Dial (DDD) modems that support this command. The level is
displayed in negative dBm. An acceptable received signal level falls between –12 and –20 dBm.
For most commands, NMS enables you to specify the destination for the command’s results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level: Help Desk, Data Technician, Manager, System Administrator
Abbreviation: rsl
Restrictions: None
Routine: Yes
Schedule: Yes
Related Commands: Receive Signal Quality (rsq)
Signal Profile (sp)
Receive Signal Level Input Form
This input form contains the following field:
Device(s) (Required field)
Enter the device(s) for which the receive signal level will be estimated. One or more
devices may be entered. Standard addressing format applies to the input. For information
on device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network
Management System User’s/System Administrator’s Guide.
Receive Signal Level Results Form
This results form displays device information for each device specified, and displays the estimated
received signal level (in dBm).