Filter
Top Products
COMSPHERE 6800 Series Network Management System
2-122 January 1997 6800-A2-GB31-20
Display Call Directory (dscd)
Use the dscd command to display the telephone numbers stored in the call directory of a
COMSPHERE 3800 Series modem, a COMSPHERE 3400/4400 Series modem equipped with a
DBM, or a COMSPHERE 3600 Series DBM. To change the telephone numbers, refer to the
Change Call Directory (chcd) command.
The 3600 Series DSUs contain 10 entries, one per telephone number. The DBM-V option has only
4 entries. For 3400/4400 Series modems, the telephone numbers are used by the Dial (dial) and
Standby Facility (sf) commands to place calls and initiate backup.
For most commands, NMS enables you to specify the destination for the command’s results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level: Help Desk, Data Technician, Manager, System Administrator
Abbreviation: dscd
Restrictions: None
Routine: Yes
Schedule: Yes
Related Commands: Change Call Directory (chcd)
Clear Call Directory (clcd)
Dialing (dial)
Change Telephone Numbers (chtn)
Display Telephone Numbers (dstn)
Display Call Directory Input Form
This input form contains the following fields:
Device (Required field)
Enter the device for which the telephone number is to be displayed. Standard addressing
format applies to the input. For information on device addressing, refer to Appendix D of
the COMSPHERE 6800 Series Network Management System User’s/System
Administrator’s Guide.
Directory number (Required field)
Specify the directory whose number should be displayed.
For COMSPHERE 3400/4400 Series modems equipped with a DBM, valid entries are
from 1 through 4.
For COMSPHERE 3600 Series DSUs and 3800 Series modems, valid entries are from 1
through 10.