Filter
Top Products
COMSPHERE 6800 Series Network Management System
2-116 January 1997 6800-A2-GB31-20
Disable/Enable (de)
(Disruptive)
Use the de command to enable or disable the transmitter on COMSPHERE or DATAPHONE II
APL modems and COMSPHERE or DATAPHONE II DSUs.
For most commands, NMS enables you to specify the destination for the command’s results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level: Data Technician, Manager, System Administrator
Abbreviation: de
Alternate: dsab
Restrictions: When a device is disabled, primary data is affected; but the secondary
diagnostic channel operates and the device responds to polls from the
NMS. (This is not applicable to a COMSPHERE 3600 Series device.)
Routine: Yes
Schedule: Yes
Related Commands: None
Disable/Enable Input Form
This input form contains the following fields:
Device(s) (Required field)
Enter the device(s) to be disabled/enabled. One or more devices may be specified.
Standard addressing format applies to the input. For information on device addressing,
refer to Appendix D of the COMSPHERE 6800 Series Network Management System
User’s/System User’s/System Administrator’s Guide.
Device state (Required field)
Enter the desired device state. Valid entries are disable and enable.
A pop-up menu is available listing valid selections.