Filter
Top Products
2Modem/DSU Commands
2-1296800-A2-GB31-20 January 1997
Display External Leads States (dsels)
Use the dsels command to display the states of two external control interface leads which are
presented as outputs at the connectors on a COMSPHERE 3400/4400 Series modem, a
COMSPHERE 3600 Series DSU/DBM or a COMSPHERE 3800 Series modem. To change the
states of the leads, or for additional information on the fields that display when you access the
dsels command, refer to the Change External Leads States (chels) command.
For most commands, NMS enables you to specify the destination for the command’s results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level: Help Desk, Data Technician, Manager, System Administrator
Abbreviation: dsels
Restrictions: None
Routine: Yes
Schedule: Yes
Related Commands: Change External Leads States (chels)
Display External Leads States Input Form
This input form contains the following field:
Device(s) (Required field)
Enter the device(s) whose external lead states are to be displayed. One or more device(s)
may be specified. Standard addressing format applies to the input. For information on
device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network
Management System User’s/System Administrator’s Guide.