Filter
Top Products
COMSPHERE 6800 Series Network Management System
2-92 January 1997 6800-A2-GB31-20
Configuration Change Notification Enable/Disable (ccned)
Use the ccned command to enable or disable the reporting of a configuration change on a
COMSPHERE device.
Whenever a configuration change is made to a device from the NMS or the front panel, the modem
can store the details of the change and display them later using the Configuration
Change Notification (ccn) command.
For most commands, NMS enables you to specify the destination for the command’s results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level: Data Technician, Manager, System Administrator
Abbreviation: ccned
Restrictions: None
Routine: Yes
Schedule: Yes
Related Commands: Configuration Change Notification (ccn)
Configuration Change Notification Enable/Disable Input Form
This input form contains the following fields:
Device(s) (Required field)
Enter the device(s) whose configuration change notification will be enabled/disabled. One
or more devices may be specified. Standard addressing format applies to the input. For
information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series
Network Management System User’s/System Administrator’s Guide.
CCN state (Required field)
Specify whether or not the CCN reporting feature should be enabled. Valid entries are
enable or disable.
A pop-up menu is available listing valid selections.
Set CCN event (Required field)
If configuration change notification has been enabled for this device, use this field to
determine whether or not this particular configuration change will be reported to the
NMS.
Enter yes to report this change to the NMS.
Enter no to prevent this change from being reported to the NMS.
If configuration change notification has been disabled for this device, configuration
changes are not reported to the NMS regardless of what is entered in this field.
A pop-up menu is available listing valid selections.