Filter
Top Products
2Modem/DSU Commands
2-976800-A2-GB31-20 January 1997
Device Health and Status (dhs)
Use the dhs command to obtain health and status reports from DATAPHONE II or COMSPHERE
devices. The health and status (alerts) of the devices downstream from the selected device can also
be reported.
For most commands, NMS enables you to specify the destination for the command’s results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level: Help Desk, Data Technician, Manager, System Administrator
Abbreviation: dhs
Restrictions: None
Routine: Yes
Schedule: Yes
Related Commands: None
Device Health and Status Input Form
The Device Health and Status input form enables you to specify the device(s) for which health and
status (alerts) information is to be reported, and allows you to specify reporting for a single modem
or for a subnetwork.
This input form contains the following fields:
Device(s) (Required field)
Enter the device(s) from which health and status reports will be obtained. One or more
devices may be specified. Standard addressing format applies to input. For information on
device addressing, refer to Appendix D of the COMSPHERE 6800 Series Network
Management System User’s/System Administrator’s Guide.
Type (Required field)
Specify whether health and status should be obtained from only the devices specified or
from the specified devices and their downstream devices.
NOTE
DATAPHONE II devices always return subnetwork health and
status results.
Enter single to obtain health and status from only the device(s) specified.
Enter subnetwork to obtain health and status from both the specified device and its
downstream device(s).
A pop-up menu is available listing valid selections.