Filter
Top Products
2Modem/DSU Commands
2-1596800-A2-GB31-20 January 1997
Exception Reports (er)
(Disruptive Based on Test Type)
Use the er command to obtain exception reports for one or more of the tests listed below.
Exception reports are tabular listings of command results statistics for a specified command.
Exception reporting allows you to run tests and receive selective results based on the test reporting
thresholds established through the Change Exception Reporting Thresholds (chert) command.
• Exception reports can be run for the following tests:
• Automatic Network Test
• Circuit Loss Inbound
• Circuit Loss Outbound
• Device Test
• Digital Test
• End-to-End Test
• Offline Test
• Receive Signal Level
• Receive Signal Quality
• Report Terminal Power
• Signal Profile
NOTE
You can change reporting thresholds for exception reporting only for
the following DATAPHONE II modems: 2024A, 2024T, 2048A,
2048C, 2048T, 2144A, 2248A, 2296A, 2192A.
For most commands, NMS enables you to specify the destination for the command’s results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level: Help Desk, Data Technician, Manager, System Administrator
Abbreviation: er