Filter
Top Products
2Modem/DSU Commands
2-1196800-A2-GB31-20 January 1997
Display Alert Information (dsai)
Use the dsai command to display the message describing the reason for a facility (FA) or modem
(MD) alert on a DATAPHONE II 2700 Series DSU.
For most commands, NMS enables you to specify the destination for the command’s results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level: Help Desk, Data Technician, Manager, System Administrator
Abbreviation: dsai
Alternate: dsfi
Restrictions: None
Routine: Yes
Schedule: Yes
Related Commands: None
Display Alert Information Input Form
This input form contains the following field:
Device(s) (Required field)
Enter the device(s) for which the fault information messages should be displayed. One or
more devices may be specified. Standard addressing format applies to the input. For
information on device addressing, refer to Appendix D of the COMSPHERE 6800 Series
Network Management System User’s/System Administrator’s Guide.
Display Alert Information Results Form
Figure 2-33 is a sample Display Alert Information results form. This results form contains both
facility alerts and modem failures.