Filter
Top Products
COMSPHERE 6800 Series Network Management System
2-118 January 1997 6800-A2-GB31-20
Display Address (dsa)
Use the dsa command to display the network address and carrier/slot location of a COMSPHERE
3400/4400 Series modem, a COMSPHERE 3600 Series DSU, a COMSPHERE 3600 Series DBM,
or a COMSPHERE 3800 Series modem.
For most commands, NMS enables you to specify the destination for the command’s results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level: Help Desk, Data Technician, Manager, System Administrator
Abbreviation: dsa
Restrictions: This command will execute only for a device with a correct serial number
entry in the device profile.
Routine: Yes
Schedule: Yes
Related Commands: Change Address (cha)
Display Address Input Form
This input form contains the following field:
Device(s) (Required field)
Enter the device(s) whose addresses are to be displayed. One or more devices may be
specified. Standard addressing format applies to the input. For information on device
addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management
System User’s/System Administrator’s Guide.
Display Address Results Form
The results form displays device information for each device specified. The Address field in the
header displays the link level address in the format link level address/serial number where link
level address is the address of the upstream device. In addition, the form displays the network
address of the device, and the carrier and slot where the device is located.
An error message displays if there is no serial number for the device in the device profile.