Filter
Top Products
2Modem/DSU Commands
2-1256800-A2-GB31-20 January 1997
Display Canned Message (dscm)
Use the dscm command to display the six stored messages in a COMSPHERE 3400/4400 Series
APL modem. The canned messages are up to 40 characters long and can be sent to an upstream or
downstream device, or to the NMS from the front panel of a 3400/4400 Series APL modem.
NOTE
You can only transmit canned messages from the front panel of a
COMSPHERE modem. Use the Send Message (
snm
) command to
send a user-defined variable message from the NMS to a
COMSPHERE modem.
For most commands, NMS enables you to specify the destination for the command’s results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level: Help Desk, Data Technician, Manager, System Administrator
Abbreviation: dscm
Restrictions: None
Routine: Yes
Schedule: Yes
Related Commands: Change Canned Message (chcm)
Send Message (snm)
Display Canned Message Input Form
This input form contains the following fields:
Device(s) (Required field)
Enter the device(s) whose canned messages are to be displayed. One or more devices may
be specified. Standard addressing format applies to the input. For information on device
addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management
System User’s/System Administrator’s Guide.
Message number (Required field)
Enter the number of the message to be displayed. Valid entries are from 1 through 6. A
pop-up menu is available listing valid selections.
Display Canned Message Results Form
The results form lists device information for each device specified, and displays the selected
canned message associated with each device.