Filter
Top Products
2Modem/DSU Commands
2-1996800-A2-GB31-20 January 1997
Signal Profile (sp)
Use the sp command to estimate facility parameters for a leased or switched transmission facility.
This command can be sent to DATAPHONE II APL and DDD modems.
For most commands, NMS enables you to specify the destination for the command’s results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level: Help Desk, Data Technician, Manager, System Administrator
Abbreviation: Abbreviation: sp
Restrictions: None
Routine: Yes
Schedule: Yes
Related Commands: Receive Signal Level (rsl)
Receive Signal Quality (rsq)
Signal Profile Input Form
This input form contains the following field:
Device(s) (Required field)
Enter the device(s) to which this command will be sent. One or more devices may be
specified. Standard addressing format applies to the input. For information on device
addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management
System User’s/System Administrator’s Guide.
Signal Profile Results Form
A sample Signal Profile results form is shown in Figure 2-62.