Filter
Top Products
COMSPHERE 6800 Series Network Management System
2-74 January 1997 6800-A2-GB31-20
Change Thresholds (cht)
Use the cht command to set thresholds on COMSPHERE 3400/4000 Series modems that will
determine when alerts should be generated. Threshold (TH) alerts will be generated when the line
parameters exceed the thresholds defined by this command.
For most commands, NMS enables you to specify the destination for the command’s results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level: Data Technician, Manager, System Administrator
Abbreviation: cht
Restrictions: None
Routine: Yes
Schedule: Yes
Related Commands: Display Thresholds (dst)
Circuit Quality (cq)
Change Thresholds Input Forms
There are two pages for the Change Thresholds input form.
Page 1
Page 1 enables you to specify the device(s) for which you want to change threshold values. This
input form contains the following field:
Device(s) (Required field)
Enter the device(s) for which thresholds are to be changed. One or more devices may be
specified. Standard addressing format applies to the input. For information on device
addressing, refer to Appendix D of the COMSPHERE 6800 Series Network Management
System User’s/System Administrator’s Guide.
Page 2
Page 2 enables you to change the threshold parameters as applicable for the device specified.
Figure 2-17 is a sample of Page 2 of the Change Thresholds input form.