Filter
Top Products
2Modem/DSU Commands
2-1076800-A2-GB31-20 January 1997
Callback directory
Use this option ONLY for 3400/4400 Series devices with a DBM. This field indicates
which directory entry to use for callback. Valid entries are 1 through 4.
A pop-up menu is available listing valid selections.
Option strap area
Use this option ONLY for 3400/4400 Series devices with a DBM. This field determines
which strap area to use for certain dialing options when establishing a dial line.
The following are valid entries:
• active – uses the set of options under the currently designated device.
• cust1 – user-defined options.
• cust2 – user-defined options.
A pop-up menu is available listing valid selections.
Disconnect existing call before execution (Required field)
Enter yes to break an existing connection so that your call will go through.
Enter no to prevent the termination of a connection when you initiate a call. If there is an
existing connection when you initiate a call, you will receive an error message indicating
that the call cannot be placed to the device.
A pop-up menu is available listing valid selections.
Select call originating speed (Required field)
Specify the speed (in bps) at which the call will be originated.
Valid entries are current (uses the current designated speed), 300, 1200, 2400, 4800, 7200,
9600, 14400, 19200, 56000.
For COMSPHERE devices, the only valid entry is current.
A pop-up menu is available listing valid selections.
Dial Command Results Form
The Dial command results form displays device information for each device specified. If the
command was successful, a results message indicates the speed at which the connection was made.
If the command was unsuccessful, a results message indicates the reason (as returned from the
device) for the connection failure.