Chapter 1 Getting Started
ViewStation User Guide 4 www.polycom.com
1. Place the ViewStation unit on top of the television monitor as
shown in Figure 1-1. Ensure that the front lip of the ViewStation
unit hangs over the edge of the television monitor.
Note Verify that the top surface area on the monitor is adequate
to support the ViewStation. The surface area of the
television monitor should provide enough support to prevent
the ViewStation from sliding off the monitor.
Figure 1-1. Placing the ViewStation
2. Connect the required cables to the back of the ViewStation as
shown in the ViewStation QuickStart card.
3. Center the microphone pod on a flat surface between the
meeting participants and the ViewStation.
4. Connect optional equipment, such as an additional television
monitor, a Video Cassette Recorder (VCR), a laptop, or a
document camera to the back of the ViewStation.
Secure all loose cables with the provided cable tie. This prevents
cables from getting tangled.
1. Slide one end of the cable tie through the square plastic cable
holder.
2. Attach the square connector to the back of the television
monitor.
Connecting the ViewStation to the ISDN or DCP Network
This section describes how to connect the ViewStation with the
following options to an ISDN or DCP network: